[HVAC Contractor]
Furnace repair Totowa
- Licensed plumbing + HVAC
- Insured
- Open 24/7
- On site within the hour
- Google rated
Why customers need furnace repair
The first cold night of the season is our busiest phone night of the year. A furnace that sat all summer gets called on and does not answer. The furnace repair calls we take in Totowa are usually no heat at all, a unit that lights then shuts off after a minute, a blower that runs but the air stays cool, banging on startup, or a burning smell the first time it fires.
What furnace repair includes
We check the igniter, flame sensor, gas valve, pressure switch, inducer motor, limit switch, blower motor and capacitor, plus the thermostat and the filter, because a filter packed solid trips the high limit and mimics a dead furnace. High efficiency units get the condensate trap and drain cleared, since a backed-up trap trips the pressure switch. We also look at the heat exchanger and will not put a cracked one back in service.
How long furnace repair takes
Most furnace repairs are one visit, sixty to ninety minutes. A flame sensor cleaning or igniter swap is quick. A blower motor or inducer replacement runs closer to two hours. Intermittent lockouts take longer because we need to watch the unit cycle a few times rather than guess from the fault code alone.
What to expect when we do the work
No heat gets answered at any hour, holidays included, and we are usually there within the hour. Price comes before the work. We explain what failed in plain language and show you the part. Before packing up we run the furnace through a full cycle, check the temperature rise, and make sure it starts cleanly on the next call for heat.
This job sits under our hvac contractor totowa work. If you would rather write it out than call, use the contact page.